SPECIFICATIONS
The application “AEL-CM1” includes the following elements:
• N-ALI01. Industrial Main Power Supply Module.
Supply voltage: 400 VAC, 3PH+N+G.
ON-OFF removable key.
Output voltage connections:
Three-Phase + Neutral: 400 VAC
Single-Phase: 230 VAC
Three-Phase supply hose with IP44 3PN+E 32A 400V connecting plug.
Differential magnetothermal, 4 poles, 25A, 300mA AC 6KA.
• N-PUL02. Emergency Stop Push-Button Module.
Emergency push-button to connect or disconnect the control circuit.
Nominal voltage: 24 VAC
Contacts:
One Normally Open Contact (NO)
One Normally Close Contact (NC)
Ground terminal.
• N-PUL48. 3 Double Chamber Push-Buttons.
Two independent chambers.
Nominal voltage: 24 VAC.
Three double chamber push-buttons (green and red).
Contacts:
Three Normally Open Contacts (NO) for green switch
Three Normally Close Contacts (NC) for red switch
Ground terminal.
• N-LAM02. Auxiliary Lamps.
Nominal voltage: 24 VAC.
Three lamps (red, yellow and green).
Ground terminal.
• N-CON01. 3-poles Contactor (24 Vac). (2 Units).
Nominal voltage for power contacts: 400 VAC.
Nominal voltage for control contacts: 24 VAC.
Nominal voltage for the control coil: 24VAC.
Contacts:
One three-phase Normally Open Contact (NO) for power circuit
Three Normally Open Contacts (NO) for control circuit
Two Normally Close Contacts (NC) for control circuit
Ground terminal.
• N-REL30. Synchronization Relay.
Nominal voltage for power contacts: 400 VAC.
Nominal voltage for control contacts: 24 VAC.
Nominal voltage for the control coil: 24VAC.
Contacts:
One three-phase Normally Open Contact (NO) for power circuit
Three auxiliary contacts:
One instantaneous Normally Open Contact (NO)
One time Normally Open Contact (NO)
One time Normally Close Contact (NC)
Ground terminal.
• N-ALI03. AC Auxiliary Power Supply (24 Vac) Module.
Supply voltage (Single-Phase): 230 VAC PH+N+G.
Output voltage:
Single-Phase 24 VAC/12 VAC.
24 VDC.
0 – 24 VDC through potentiometer.
AEL-CM1 | LOGICAL CONTROL OPERATIONS APPLICATION
The Logical Control Operations Application, “AEL-CM1”, has been designed by EDIBON to study basic logics operations using timers, push-button, signaling lamps, contactors, thermal relays and combinations of them used in the industrial world.
This application allows the students acquire knowledge about how carry out different logic wirings with several relays and circuit breakers. The user will learn a lot of control logics, for example “OR” and “AND” logic, locking systems, etc.
These control logic are very much used in the industry to automate processes or other operations, such as starting of motors.
This application includes all necessary elements for programming the basics control logic and lamps which show the circuit breakers state.
