SPECIFICATIONS
• N-KNX34. KNX/EIB USB Programming Interface Module.
Power supply: KNX line, 21…30 VDC.
Current consumption (max.): < 5 mA.
USB connection: USB2.0 connector.
• N-KNX18. KNX/EIB Power Supply Module.
Power supply: 230 VAC.
Maximum load: 640 mA.
Output voltage: 24 VDC.
• N-KNX14. KNX/EIB Light Sensor Module.
KNX bus voltage: 24 VDC.
Bus inputs/outputs: 2 mm safety sockets.
Photosensitive cell.
• N-KNX24. KNX/EIB Shutter/Blind Actuator Module.
Nominal voltage: 230 VAC.
Frequency: 50 Hz.
Mains inputs/outputs: 4 mm safety sockets.
• N-KNX20. KNX/EIB Push-Button Module.
KNX bus voltage: 24 VDC.
Switch ON/OFF.
Mains inputs/outputs: 4 mm safety sockets.
Bus inputs/outputs: 2 mm safety sockets.
• N-KNX23. KNX/EIB Shutter Motor Module.
Nominal voltage: 230 VAC.
Frequency: 50 Hz.
Nominal power: 100 W.
• N-KNX21. KNX/EIB Room Controller Module.
KNX bus voltage: 24 VDC.
Bus inputs/outputs: 2 mm safety sockets
• N-KNX30. KNX/EIB Touch Panel Module.
Nominal voltage: 230 VAC.
Frequency: 50 Hz.
KNX bus voltage: 24 VDC.
Mains inputs/outputs: 4 mm safety sockets.
Bus inputs/outputs: 2 mm safety sockets.
• N-KNX25. KNX/EIB Single Line Extending Bus Module.
Nominal voltage: 230 VAC.
Frequency: 50 Hz.
KNX bus voltage: 24 VDC.
Mains inputs/outputs: 4 mm safety sockets.
Bus inputs/outputs: 2 mm safety sockets.
Interconnection with other KNX/EIB systems.
• N-KNX2. KNX/EIB Additional Power Supply Module.
KNX bus voltage: 28 VDC.
Bus inputs/outputs: 2 mm safety sockets.
• N-KNX32. KNX/EIB Weather Station Module.
Nominal voltage: 230 VAC.
Frequency: 50 Hz.
KNX bus voltage: 24 VDC.
Mains inputs/outputs: 4 mm safety sockets.
Bus inputs/outputs: 2 mm safety sockets.
Different configurations:
Day/night.
Winter/summer.
This module allows measure:
Outside temperature.
Wind speed.
Level of external brightness.
• All necessary cables to realize the practical exercises are included.
Cables and Accessories, for normal operation
AEL-KNX1 | KNX/EIB SHUTTER CONTROL APPLICATION
The KNX/EIB Shutter Control Application, “AEL-KNX1”, has been designed by Edibon to show the users the working of shutter control, intended to improve the energy efficiency and the comfort of their occupants. Blind and shutter control can be done manually through switches or automatically with a constant close loop control with which the shutter and blind position is automatically adapted. These two methods allow us to get energy savings whenever the KNX devices are programmed properly.
